 | Recording |
EU.MusicianUniversity.com is an online shop for ordering from:
Sverige Danmark Österreich België Luxemburg Portugal Suomi Magyarország Liechtenstein Eesti Vabariik Latvijas Republika Lietuvos Respublika Cesko/Ceská republika Republika Slovenija Slovenská Republika Shure VP88 Studio or Live Recording M-S Stereo Microphone
| | |
| Ready to Order? | Prices Price: 899.95
€ 799,95 Price including VAT
| In Stock?: |  | | Delivery time: | 2-5 Days | | Warranty: | Official manufacturer warranty |
Not the lowest price? Seen a lower price? Request quote
| Official Dealer of:
 | Product SpecifiationsType Single-point stereo (MS configuration) condenser Frequency Response 40 to 20,000 Hz Polar Pattern Mid Cartridge: Cardioid (unidirectional) Side Cartridge: Bidirectional Output Impedance Rated at 150 (100 ohms actual). Recommended minimum load impedance: 800 ohms (may be used with loads as low as 150 ohms with reduced clipping level) Sensitivity (1 kHz, MS mode) Open Circuit Voltage: -66 dB (0.5 mV) Mid. (Side level 1.6 dB higher than Mid level) (0 dB=1 V/Pa) Side Level (Stereo mode; relative to Mid level) Low: -6.0 dB; Medium: -1.9 dB; High: +1.6 dB Clipping Level (1 kHz) 800 ohm Load (less than 1% THD) -12 dBV (0.25 V)(Mid output, 1% THD) -10 dBV (0.30 V)(Side output, 1% THD) 150 ohm Load (less than 3% THD) -25 dBV (0.06 V)(Mid output) -19 dBV (0.11 V)(Side output) Maximum SPL 800 ohm Load: 129 dB 150 ohm Load: 119 dB Hum Pickup -4 dB equivalent SPL in 1 millioersted field (60 Hz) Self Noise (Mid, Side, Left and Right outputs; equivalent sound pressure levels) 24 dB typical, A-weighted 28 dB typical, weighted per DIN 45405 Dynamic Range 105 dB (maximum SPL to A-weighted noise level) Signal�to�Noise Ratio* 70 dB (IEC 651) at 94 dB SPL *S/N ratio: difference between microphone output at 94 dB SPL and microphone self-noise A-weighted. Overvoltage Protection Maximum External Voltage applied to Pins 2 through 5 with respect to Pin 1: +/- 75 Vdc Polarity Positive pressure applied from any direction to the Mid cartridge or from the left to the Side cartridge in the MS mode, or applied from the front in the Stereo mode produces positive voltage on pin 2 relative to pin 3 (Mid/Left) and pin 4 relative to pin 5 (Side/Right). Power Phantom Supply Voltage: 9 to 52 Vdc Current Drain: 1.3 mA/output; 2.6 mA total Battery Type: 6 V cylindrical* Life: 70 hours** Current Drain: 2.4 mA total *Silver oxide (NEDA 1406SOP), lithium (NEDA 5005L), alkaline (NEDA 1414A) **Fresh silver oxide or lithium battery; 40 hours with alkaline Environmental Conditions Operating: -18 to 57 degrees C (0 to 135 degrees F) (Relative Humidity <90%) Storage: -29 to 74 degrees C (-20 to 165 degrees F) (Relative Humidity <80%) Cables Y-Splitter Cable (supplied): 0.76 m (30 in.) vinyl-jacketed, dual� shielded, 2-conductor with 5-pin female XLR connector on microphone end and two 3-pin male XLR connectors on equipment ends. Microphone Extension Cable (Model C110; optional): 7.6 m (25 ft.) vinyl-jacketed, shielded, 4-conductor with 5-pin male XLR connector on one end and 5-pin female XLR connector on other end. Case Brass and nickel-plated aluminum construction with stainless steel grille. Finished in satin black vinyl enamel Dimensions See User Guide Net Weight 417 grams (14.7 oz) less battery and cable |
The Shure Model VP88 is a single-point, stereo condenser microphone for use in professional studio recording, field production, electronic news gathering (ENG), and studio broadcasting applications. It combines two condenser cartridges in a single housing to create a stereo audio image of the sound source. It is unique in its ability to capture the realism of a live event and yet withstand rigorous field production environments.
The VP88 uses a mid-side (M-S) configuration. One microphone cartridge (Mid) faces forward to capture on-axis sound using a cardioid pickup pattern. The other microphone cartridge (Side) is bi-directional, capturing sound from either side. The VP88 contains an internal M-S matrix with three settings for different degrees of stereo image seperation. The internal matrix can be bypassed if an external matrix is used or if stereo imaging is done in post-production. Switches on the top of the microphone control output mode, stereo imaging, low-frequency rolloff settings, and battery on/off.
VP88 - Includes "Y-splitter" cable, foam windscreen, stand adapter, 6V battery and zippered storage bag. Phantom power or included battery required Single-point, stereo condenser microphone for use in professional studio recording, field production, electronic news gathering (ENG), and studio broadcasting applications.
Time-coherent, Mid-Side (M-S) design for optimal stereo imaging Built-in stereo matrix for direct control of the stereo spread; direct M-S outputs available Mono compatibility ideal for broadcast applications 40 to 20,000 Hz frequency response Low noise and distortion Wide dynamic range Switch-selectable, low-frequency rolloff (12 dB/octave below 80 Hz) for reduced pickup of ambient noise and stand vibration Operates on phantom power or a 6V camera battery LED power indicator Internal shock mount for reduced stand vibration and handling noise Built-in "pop" screen Includes windscreen, swivel adapter, and Y-cable Question about the VP88 Studio or Live Recording M-S Stereo Microphone? emailAudio, Video & Sounds Not Yet Available Related and Similar to VP88
|
Copyright © 2000-2012 EU.MusicianUniversity.com Publisher does not accept liability for incorrect spelling, printing errors (including prices), incorrect manufacturer's specifications or changes, or grammatical inaccuracies in any product included in the catalog or website. Prices subject to change without notice. |
|